Home > Brands > Dresser > Andco and Rcs Actuators > Andco Controls

Andco Controls: All

hide
Model 5100

Model 5100

The Model 5100 Control is a solid state servo device capable of driving a 10 Amp inductive load. It is designed for position or process control of an electric motor driven actuator.

 View Product Details
hide
Position Transmitter

Position Transmitter

This position transmitter outputs a 4-20mAdc signal proportional to actuator position. A potentiometer and compartment heater are required with the actuator.

 View Product Details
hide
EASC SCC-10 for Andco

EASC SCC-10 for Andco

  • Onboard LED display facilitates setup and calibration using the EASC Menu Setup.
  • Menu selection of input/output ranges including 4-20 ma, 1-5 VDC, 2-10 VDC and 0-10 VDC, or virtually any custom range required.

 View Product Details
hide
Profibus® DP for Andco

Profibus® DP

  • Two wire control reduces installation and start up time compared to multi-cable wiring.
  • Automatic calibration cuts down on start up time.

 View Product Details
hide
Device Net™ for Andco

Device Net™ for Andco

  • Provides open/stop/close or positioning control with limit switch status feedback.
  • Provides instantaneous motor reversal protection.

 View Product Details
hide
Modbus® for Andco

Modbus® for Andco

A Modbus®-485 communication network, powered by 24 VDC, allows up to 100 devices on a single channel.

 View Product Details

Copyright © 2012 Dresser Inc.